Christie IMB, User Manual

Page: 51 / 122

Manage Automation
Christie Integrated Media Block User Manual 39
020-100845-05 Rev. 1 (08-2013)
4. Select a device.
5. Tap Accept.
6. Enter a name for the device and then tap Enter.
7. Complete the Name, IP Address, Username, Password, and Serial Command Port fields.
8. Tap Save.
Control Christie ACT Automation
These are the available built-in commands for the Christie ACT:
Control INTEG JNIOR Automation
Christie recommends that you use the built-in commands to control an INTEG JNIOR device. These
are the available built-in commands:
You can create macros on the JNIOR device and call them using the Execute Macro command.
To create and run macros on the JNIOR, use the JNIOR Support Tool to enable and configure the
Cinema.JNIOR application. It is recommended that you install Cinema.JNIOR version 2.22.1115.1501
or later. For additional information, see INTEG Process Group (
www.integpg.com ).
The default Ethernet port for sending automation commands to the JNIOR is port 9200.
Command Description
ACT Ethernet cue Sends a string to the ACT Ethernet input cue.
Buzzer Activates the buzzer for the specified time (in milliseconds).
Button Simulates pressing or holding the ACT button.
Pulse relay Sends a pulse to a specific relay.
Open/Close relay Opens or closes a specific relay.
GPO pulse Sends a pulse to a specific GPO pin.
GPO set all Sets the values for all GPO pins.
Run script Runs a script on the Christie ACT.
Flash LED Causes a specific LED to flash.
Set all LEDs Sets values for all of the LEDs.
Command Description
Open relay Opens a specific JNIOR relay.
Close relay Closes a specific JNIOR relay.
Pulse relay for x ms Sends a pulse to a specific JNIOR relay for the specified time
(in milliseconds).
Execute macro x Executes a JNIOR macro.