Installation and setup
HS series 2K Installation and Setup Guide
35
020-002038-01 Rev. 1 (09-2022)
Copyright ©2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
• If pressing
FOCUS
key results in position 2 coming into focus, turn set screw A
counterclockwise.
4. Refocus position 1 and check if position 2 is also in focus. If not, repeat step 3 and 4 until both
position 1 and 2 are in focus.
5. To optimize the focus of position 3 on the screen, turn set screw C clockwise or counterclock-
wise.
• If pressing
FOCUS
key results in position 3 coming into focus, turn set screw C
clockwise.
• If pressing
FOCUS
key results in position 3 coming into focus, turn set screw C
counterclockwise.
6. Repeat from step 2 until the projected focus pattern is as sharp as possible in the center, left,
right, top, and bottom of the screen.
7. If the projector is still not in focus, reset the set screw position:
a. Turn the set screws counterclockwise until tight.
b. Turn the set screws 1.5 turns in the clockwise direction back to their factory default
setting.
c. Check that the alignment of the set screws matches what is shown in the image
above.
