Projector covers and feet
GS Series 630-635 Service Manual
54
020-001224-02 Rev. 1 (08-2018)
6. Transfer the interlock switch to the new left-side cover.
7. If required, replace the left-side cover.
8. To re-install, follow these steps in reverse order.
Removing the right-side cover
The right side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See
2. Remove the rear cover.
See
3. Remove the 11 M3 screws with a Phillips #1 screwdriver securing the top shielding.
4. Unplug the fans 1, 2 connector to the main board.
5. Unplug the keypad connector to the main board.
6. Remove the mylar which is phased on the power supply shielding.
7. Remove the four M3 screws with a Phillips #1 screwdriver.
8. Remove the right-side cover from the projector.
9. Remove the fans 1 and 2.
See
10. Remove the keypad board.
See
11. Transfer the fans and keypad board to the new right-side cover.
12. If required, replace the right-side cover.
13. To re-install, follow these steps in reverse order.
