Removing the projection lens
Use the correct method of removing the lens.
1. Push in and hold the lens release button.
2. Turn the lens counterclockwise until the lens guides are aligned.
3. Slide the lens straight out of the projector.
If the lens does not slide out easily, reset the lens offset before removing the lens.
4. Attach the lens cap to avoid damage.
Warning! If not avoided, the following could result in death or serious injury.
•
Once the lens removal has begun the safety retention features of the lens are defeated.
To re-engage the safety lock mechanism, the lens must be removed and re-inserted, or
fully rotated clockwise until a click is heard.
•
Packaging tape is required to ensure safe shipment of the projection lens to restrain the
zoom ring from rotating during shipping.
Connecting to AC power
Connect AC power to the projector.
1. Plug the AC power cord into the projector.
2. Secure the AC power cord with the power cord retainer.
Turning on the projector
When the projector AC power supply is plugged in and the breaker switch is on, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
Installation and setup
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB
26
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
