4 of 5
CP2000-M/MR Ballast Replacement Instruction Sheet
020-100511-01 Rev. 1 (05-2010)
b. Using a #2 Phillips
™
screwdriver, loosen the two captive screws on the top of the unit (Figure
4) and one on the bottom near the lamp adjuster assembly (not shown).
c. Carefully, lift the blower out of the projector housing.
6. Disconnect the AC power harness by pushing in on the clip. (Figure 5)
7. Disconnect the Ballast Communication harness by removing the two retaining screws and pulling
up (Figure 6).
Figure 6 Ballast Communication Harness
Figure 4 Remove Lamp Blower
Figure 5 AC Power Harness
