Introduction
This document provides technical information for assisting Christie qualified technicians in the
servicing of the Boxer 4K projector.
Every effort has been made to make sure the information in this document is accurate and complete.
However, due to continuing research all information is subject to change without notice. Christie
assumes no responsibility for omissions or inaccuracies.
Affected products
The following products are affected:
•
Boxer 4K30
•
Boxer 4K20
•
Mirage 304K
•
Boxer 30
Site requirements
To safely install and operate the projector, the installation location must have restricted access for
authorized personnel only and meet these minimum requirements.
Physical operating environment
Provides specifications for the operating environment.
•
Ambient temperature (operating) 5 to 40°C (41 to 104°F) up to 1500 ft
•
Humidity (non-condensing) 10 to 80%
•
Operating altitude: 10,000 ft maximum at 5 to 25 degrees Celsius ambient
Power connection
The projector uses an innovative dual AC inlet power system that offers two power modes.
To operate at full brightness (six lamps), power the projector using AC Input 1 if the appropriate high
power source is available. To operate in limited power mode (single lamp), power the projector using
standard lower power sources using AC Input 2. A different power cord is provided for each power
source. A 30A rated wall breaker is required at the installation when using Input 1. A 15A rated wall
breaker is required at the installation when using Input 2.
Boxer 4K Service Guide
7
020-101699-04 Rev. 1 (02-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for Boxer 30
Page 1: ...Service Guide 020 101699 04 Boxer 4K...
Page 113: ......