a. Connect to the projector using RS232 or Ethernet (default IP address 192.168.0.100).
b. Perform a lens calibration by sending the serial API command
(LCB+HOME 1)
to the
projector.
2. Turn off the power to the projector.
3. Remove the non-ultra-short throw lens, if installed.
4. Before mounting the bracket, align the mark lines as shown below.
5. If the two highlighted M4 x L22 screws have tightened, loosen the screws by one turn.
6. Flip the projector onto its top side.
7. Secure the support base (without lens bracket attached) to the projector.
•
For HS Series 2K, fasten two M8 x 16 screws and washers. For the front screw, slide to
hook the projector front cover and then secure the screw.
Installing the ultra short throw lens
Installing the Ultra Short Throw Lens Instruction Sheet
2
020-103312-03 Rev. 1 (10-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.