Christie 145-186106-01, User Manual

Page: 7 / 15

Installation
To install the speaker, complete the following procedures.
Connecting the speaker wires
Once the speaker is installed, connect the speaker wires to the amplifier.
Notice. If not avoided, the following could result in property damage.
• Always turn off and disconnect the amplifiers from power before making audio connections or
servicing a speaker.
1. Install the speaker according to the mounting instructions provided in this manual.
2. Connect the speaker wire to the positive (A) and negative (B) terminals on the back of the
speaker.
If creating crimped spade lug terminations, use a #8 spade lug (P/N: 145-159106-XX).
A Positive (+) connections
B Negative (-) connections
3. Connect the negative and positive speaker wires from the speaker to the corresponding
terminals on the amplifier.
4. Turn on the amplifier and verify that the speaker is receiving an input signal by playing a test
signal through the system.
Ceiling mounting the LS2C speaker
To install the loudspeaker on the ceiling, use the appropriate bracket.
1. Remove the four pre-installed M8 button head screws on the back of the loudspeaker.
2. Attach the following bracket to the back of the loudspeaker using the four M8 button head
screws.
• Ceiling mount MM-3RDX-18 (P/N: 111-683209-XX)
3. Alternately, use a properly weight rated and sized U-bracket connected with the two M8
mounting points located on the sides of the loudspeaker.
Vive Audio LS2C Speaker User Guide 7
020-103286-01 Rev. 1 (02-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.