Christie 130-002103-01, User Manual

Page: 74 / 144

62 Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Configure the Display
Serial Flow Control
Determines whether software flow control or no flow control is used when transmitting and receiving
data on the serial port.
Serial Mode
Select the serial data mode. The mode includes the number of bits, the parity and the number of stop
bits.
Serial Protocol
Select the protocol used on the serial communications port.
Projector Address
Enter a number up to 3-digits in length (such as “001”) to assign or change a number to the
projector currently in use. If the current projector already has a number assigned, that number will
appear here. Numerical identity for projectors enables you to communicate with a single projector
within a multiple-projector application. See
Proj on page 39. If you make a mistake in assigning or
changing the projector number, press Exit.
Network Routing
Separate
Select Separate (factory default) to keep RS-232,
RS-422, and Ethernet messages on their respective
paths instead of being broadcast to the other types
of ports.
RS-232 and RS-422 Joined
Messages originating from an RS-232 or RS-422 controller will be relayed to all RS-232 or RS-422
ports. Any Ethernet communication, however, will not.
RS-232 and Ethernet Joined
Messages to and from the RS-232 ports will also be relayed to the Ethernet port, and vice versa. Any
RS-422 communications will be isolated. In the case of multiple Ethernet sessions over the single
Ethernet connector, input on the RS-232 port will be relayed to all Ethernet sessions; however, input
from any Ethernet session will only be relayed to the RS-232 ports.
i
Network routing is not available when there is no serial network being used.