Aligning and focusing the image
After installing the lens, align and focus the image.
The method for performing the steps below may vary depending on projector model. For detailed
information, refer to the user documentation for your product.
1. If required, power on the projector.
2. Perform a lens calibration.
3. To align the image, position the projector and adjust offsets.
4. Adjust boresight.
5. Adjust the center focus of the image by using the Focus feature on the projector.
6. Manually adjust the corner focus of the image using the focus ring on the lens.
7. To fine tune the focus, repeat steps 5 and 6 until optimum focus is achieved.
Technical support
Technical support for Christie products is available at:
•
North and South America: +1-800-221-8025 or [email protected]
•
Europe, Middle East, and Africa: +44 (0) 1189 778111 or [email protected]
•
Asia Pacific: +65 6877-8737 or [email protected]
Ultra short throw lens installation and setup
Ultra Short Throw Lens Instruction Sheet
3
020-103300-01 Rev. 1 (12-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
