Chore-Time ULTRAFLO Cage Free, Installation And Operator'S Manual, Page: 23 / 46

Installation
23
MC2507A
Power Unit Base Installation
Suspended and Stand Systems
1.The Power Units must be located directly under a suspension drop.
2.The Power Unit, Driver Assembly, and Base Connector are shipped assembled. Disassemble the Base
Connector from the Power Unit and Driver Assembly by removing the four 1/4-20 Locknuts. (See Figure
21.) . Leave the Wear Shoe (Item 2) in place.
3.Install Trough Hangers/Supports as follows....
• Single Perch - Install Trough Hanger Tops (Item 3) and Bottoms (Item 4).
• Three Perch - Install Short 3 Perch Feeder Supports (Item 7) .
• 3 Perch Non-Suspended - Feeder Supports (Item 11) as shown . (See Figure 16 on page 19)
4.Install the End Caps (Item 10) (See Figure 20 on page 22)
5.Cut the Perch Tubes even with the End Caps and install Conduit Plugs (Item 10) as shown .
Figure 21.Power Unit Installation
8
4
10
3
10
9
1
2
11
Remove. Will be
re-installed later.
2
12
Item Description Part No.
1 1/4-20 Lock Nut 1269
2 Wear Shoe 8210
3 Hanger Top 56118
4 Hanger Bottom 56117
5 10-24 x .500 Machine Screw 1795
6 10-24 Kepnut 27725
7 Short 3 Perch UF Feeder Support 56476
8 Trough 14159-3
9 Base Connector 9636
10 End Cap 56115
11 End Connector Clamp 9634
12 1/4-20 x .5 Bolt 1487
13 1" Conduit Plug 56264
14 Three Perch Non-Suspended
Feeder Supports
56418
Single Perch Suspended
Three Perch Suspended
7
13
14
Three Perch Stand
4
6
6 5
5
8
6" [152.4mm]
Maximum
6" [152.4mm]
Maximum