Load Cell Indicator
Control Installation
MT2316A
11
Alarm Messages
SJB 1 (or 2) IO Net Error
This alarm will occur when the LCI can not communicate with one of the SJB boxes. Check to make sure that
the SJB boxes are connected properly to LCI, that the address DIP switches are set properly and that there is
power to the SJB. See the wiring diagram on page 14 for information on connecting the SJB to the LCI.
Service Alarms
Listed below are additional alarm codes that relate to the internal operation of the LCI. Contact the nearest
Chore-Time Distributor or CTB service personnel if one of these alarms occur.
Mounting the Control
The LCI Control requires a minimum mounting area of
approximately 10" x 14" [55.9 cm x 55.9 cm] This
dimension is allowing extra room for the Control Door
to open.
(See Figure 12)
. The box should be mounted
level on a solid backing using the mounting holes
provided.
SYSTEM FAILURE 100
SYSTEM FAILURE 111
ERROR 1
ERROR 2
ERROR 3
ERROR 4
ERROR 5
ERROR 6
ERROR 7
ERROR 8
ERROR 20
ERROR 21
ERROR 22
ERROR 23
ERROR 27
ERROR 29
ERROR 30
ERROR 33
ERROR 34
ERROR 35
ERR 103
Control Installation
Approx. 10"
Extra room for Door to open
Approx. 14"
Figure 12. Control Mounting