CHMER Wire-Cut EDM Operation Manual W5F
Note:
1. Additionally increases the JOG speed to be 2 steps.
Setting method: Press H or M key twice in 1 second. Flash indicator
means that setting is finished.
2. The value of STEP JOG feed-rate override may adjust in the mode
Help-2>
「
System Double Value Parameter
」
, PA#42~PA#47 (
We
strongly recommend user may not modify the value at will,
otherwise it may cause unexpected damage to machine tool.
)
3.
H, M, ML, L
These four keys are for speed setting under JOG mode. However, they are for
moving distance setting under STEP JOG mode.
Note:
1. Additionally increases the JOG speed to be 2 steps.
Setting method: Press H or M key twice in 1 second. Flash indicator
means that setting is finished.
2. The value of STEP JOG feed-rate override may adjust in the mode
Help-2>
「
System Double Value Parameter
」
, PA#42~PA#47 (
We
strongly recommend user may not modify the value at will,
otherwise it may cause unexpected damage to machine tool.
)
4.
+U/+X
，
-U/-X
，
+V/+Y
，
-V/-Y
，
+Z
，
-Z
These are axis direction keys. Under JOG or STEP JOG mode, they could
control the moving direction of the worktable.
5.
UV/XY
This is direction switch key. When the indicator is lit, it represents XY plane. On
the contrary, it becomes UV plane. (Parameter 68 bit 1)
6.
VERT
Press twice quickly, then worktable will return to vertical point; it ends up
when the LED lights on.
7.
S
.
PT
This key is for start point quick return. When it is pressed, the worktable will
return to start point quickly. If the indicator is lit, it represents that the present
position is the start point.
1-7
