•
Frost formation
on the refrigerator
top side
Does the refrigerator door sink?
•Adjust the lower hinge shaft to raise the
refrigerator door, so that the door gasket
sealing performance can be improved.
(
Note: If the above descriptions are inapplicable to troubleshooting, do not disassemble and repair it yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact the local store where
your purchase was made. This product should be serviced by an authorized engineer and only genuine spare parts
should be used.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the
appliance, leaving the door ajar to prevent unpleasant smells.)
Reversing the door
To dismantle the refrigerator door
a) Use a tool to remove the screws from the upper
hinge cover, remove the upper hinge, and
install the communication wire into the hole on
the top of the refrigerator.
b) Screw off the three bolts on the upper hinge,
remove the upper hinge, and pry off the upper
hinge cover, door sleeve, magnet.
c) Put the door communication wire into the hole
on the door, and then cover it.
d) Remove the three bolts from the hinge cover on
the left-side top of the refrigerator, remove the
hinge cover, take out the wire harness in the
hole, and install the door shaft sleeve.
e) Lift the refrigerator door up by 50mm to remove
the refrigerator door.