Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service
technician install an outlet near the appliance. Use of an extension cord can negatively affect the performance of the
unit.
Prepare with requirements
Installation Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your Fridge/Freezer near a heat source, eg. cooker, boiler or radiator.Also avoid direct sunlight
in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or annex
ensure that the Fridge/Freezer is placed above the damp course, otherwise condensation will occur on the Fridge/Freezer
cabinet. Never place the Fridge/Freezer in a wall recess or into fitted cabinets or furniture. When your Fridge/Freezer is
working, the grille at the back may become hot and the sides warm. Therefore, the back part of the refrigerator / freezer
must be installed at least 30mm of free space, both sides should be left more than 300mm. Do not drape the
Fridge/Freezer with any covering.
Dimensions in mm
W
D
H
A
B
C(
°
)
E
F
700
700
1680
1350
1350
125
30
300
Fig. 1 Fig. 2
Note
：
Figure 1, Figure 2 only as a product space demand size schematic diagram.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may
cause you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final location,
adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of bicarbonate of soda. Then rinse with warm water using a damp
sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely before replacing in the Freezer.
The external parts of the Freezer can be cleaned with wax polish.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before switching back on
to allow the coolant fluid to settle.
Before filling your Freezer
Before storing foods in your Freezer, turn the Freezer on and wait for 24 hours, to make sure it is working properly and to
allow the Freezer to fail to the correct temperature. See page 5 for more details.
INTRODUCTION
Before use
Please read these instructions and the Safety guidelines on page 1 carefully before using your new Fridge/Freezer. The
Fridge/Freezer is for indoor, domestic use only.
General Description of Refrigerator
