3
INSTALLATION
Installing Your Refrigerator
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.
Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air ventilation. Adjust the
feet to keep the refrigerator level.
Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Ambient temperature below 50°F or
above 85°F will hinder the performance of this appliance. This unit is not designed for use in a garage or any other
outside installation.
Avoid locating the refrigerator in moist areas.
Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized service center. This unit is not designed to be installed in an RV
or used with an inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down
for 2~3 hours under before placing food in the refrigerator or freezer compartment.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may
cause you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final
location, adjust the leveling feet at the front by turning them.
Cleaning before use
