SAFETY INSTRUCTIONS
Use and care
•
•
Only use the machine for the purpose it was intended for.
Keep all parts in good working order and ensure that all
fixtures are properly tightened.
Never use a machine that is faulty. Carry out the checks,
maintenance and service instructions described in this
manual. Some maintenance and service measures must
be carried out by trained and qualified specialists. See
instructions under the heading Maintenance.
Do not modify safety equipment. Check regularly that they
function as they should. The machine must not be run with
defective or disassembled safety equipment.
Never use a machine that has been modified in any way
from its original specification.
Machinery should only be started when grinding heads
are resting on the ground unless carrying out a testing
procedure as outlined in this manual.
The machine should not be started without the rubber
dust skirt attached. It is essential a good seal between
machine and floor be established for safety, especially
when operating in dry grinding applications.
During grinding, the machine must be connected to a
vacuum cleaner to sucking off the dust.
When changing the grinding discs ensure power supply to
the unit is OFF by engaging the Emergency Stop button
and the power-plug disconnected.
After each grinding/polishing operation always remove the
diamond tools.
Make sure that the rubber skirt is intact and clean and that
it seals tightly against the floor. Damaged rubber skirt
should always be replaced.
When removing glue, asphalt, paint etc. always raise the
machine from the surface after use to prevent it from
sticking to the floor due to the heat. Make sure the
grinding head has stopped rotating before raising the
machine.
Diamond tools may be very hot after use. Leave machine
to cool off before removing the diamond segments. Use
protective gloves.
Always use the machine mounted lifting eye when lifting.
Always carry the machine by the carrying handle and the
handle.
•
•
•
•
•
•
•
•
•
•
•
•
•
Transport and storage
• The machine should always be transported under cover
limiting the exposed to natural elements – in particular
rain and snow.
Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
The machine should always be stored in a dry place when
not in use.
•
6
•
http://www.honwaymachinery.com
