China Electronics Technology Instruments AV3672 Series, User Manual

Page: 209 / 424

6 Measurement Optimization
6.11 Rapid Data Transmission
205
Click the [Channel] box in the trigger setting zone and select Channel 1 .
Click the [Continuous] radio box in the trigger setting zone.
3) Set the trigger mode of Channel 2: update measurement data when required.
Click the [Channel] box in the trigger setting zone and select Channel 2 .
Click the [Single] or [Groups] radio box in the trigger setting zone. If the group triggering mode is selected,
enter the group number in the [Groups] input box.
4) Click [Soft keyboard] in the [System] menu. The [Soft keyboard] dialog box will appear. Click [Stimulus] >
[Trigger] in the dialog box and the toolbar to trigger the corresponding soft key will appear.
5) Click the window below to set Channel 2 as the current active channel.
6) Update the measurement data of Channel 2.
7) Click the [Single] , [Groups] or [Re-sweep] on the trigger soft key toolbar. Measurement data of Channel 2 will
be updated.
6.10.2 Automatic Change of Measurement Setting
Automatically change measurement settings by means of programming to effectively improve the efficiency of
multi-parameter measurements.
6.10.3 Rapid recalling of measurement
The most effective method to recall the measurement is to save a group of measurements as one instrument state.
➢
The time difference of recalling the instrument with one or more measurements is little.
➢
The corresponding time is required in each recalling. The recalling time can be saved by setting a group of
measurements.
6.11 Rapid Data Transmission
Rapid data transmission can help to improve the measurement efficiency. You can apply the following methods to
increase the data transmission velocity.
●
Rapid recalling of measurement
·················································································· 205
●
Minimization of transmission data
················································································ 206
●
Use of real number format
························································································ 206
●
Use of LAN
········································································································ 206
●
Use of COM program
······························································································ 206
6.11.1 Use of “Single” Trigger Mode
Use the “single” trigger mode to complete measurement before data transmission.
Menu path: [Stimulus] > [Trigger] > [Trigger...] . The [Trigger ] dialog box will appear.
Select the [Internal] radio box in the trigger source zone.
Select the measurement channel for data transmission by clicking the [Channel] box in the trigger setting zone.
Click the [Continuous] radio box in the trigger setting zone and then click [OK] to close the dialog box.
Update the measurement results:
1) Click the corresponding trace state button to set the trace and channel to be updated as the active trace and
channel.
2) Click [Soft keyboard] in the [System] sub-menu. Then click [Stimulus] > [Trigger] in the [Soft keyboard]
dialog box.