ChimneyFree 18WM20124, User Manual

Page: 35 / 39

www.tsicustomerservice.com A153R1
7
2. Carefully tilt front frame assembly forward a couple
of inches. Then lift complete glass assembly up and
away from unit (Fig. 2).
1. Turn the master power switch off, then unplug
the power cord from the wall outlet.
If fireplace has been operating, let the unit cool
at least one hour.
Locate and rotate the 2 screws on the front frame
assembly in counterclockwise direction to loosen
the front frame assembly from insert. (Fig. 1).
3. Locate the two ember bed securing nuts on the left
and right sides of the log set. These securing nuts
are disguised as wooden embers (Fig. 3).
4. Turn nuts counterclockwise to loosen, remove and set
aside. Securely grab logs on left and right side and lift
log/ember bed assembly straight up. Once ember bed
has cleared the support bracket and threaded rods,
bring log/ember bed assembly forward and out of unit
and set aside in a safe place (Fig. 4).
Wooden
Ember Nut
Logs/Ember bed
Ember bed Mounting Post
4
5. Unhook light bulb spring clips from the bulbs, and
unscrew the bulbs (Fig. 5) After replacing the
bulbs make sure to replace the light bulb spring
clip.
Follow steps 1 through 4 in reverse order to
reinstall front frame assembly into your insert.
Ember bed Light Bulb
Light Bulb Holding Spring
Pull
Pull
5
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the heater and away
from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a clean soft
cloth. Do not use brass polish or household cleaners as these products will damage the metal trim. Citrus oil-based
products can be obtained at supermarkets or hardware stores.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, we recommend periodic cleaning/vacuuming of the fan/heater.
• Make sure the unit is turned off and unplugged whenever you are cleaning the heater or fireplace.