Status: 12/2021 - Version 1.01
Page 2
Details variants: (EEKL = energy efficiency class according to 2019/2020 / EU & 2019/2015 / EU)
PIR wall lights
Item No.
Color / type
power
Consumption / 1000h
Lumens
Kelvin
EEKL
dimmable
Dimensions / Ø
Operation on
23090
white / Payar ww
15 watts
15KWh
1520lm
3000K
E.
no
ØxD 210 x 49mm
230V / 50Hz
23091
white / Payar nw
15 watts
15KWh
1570lm
4000K
E.
no
ØxD 210 x 49mm
230V / 50Hz
23092
white / Nias ww
10 watts
10KWh
980lm
3000K
E.
no
212 x 120 x 45mm
230V / 50Hz
23093
white / Nias nw
10 watts
10kWh
1010lm
4000k
E.
no
212 x 120 x 45mm
230V / 50Hz
23154
gray / Payar nw
15 watts
15KWh
1570lm
4000k
E.
no
ØxD 210 x 49mm
230V / 50Hz
safety instructions
• Never open the product, there are no serviceable parts - only by qualified personnel.
• The product must not be exposed to heat (> 40 °) or high UV radiation.
• Before connecting, check that the operating voltage (product) matches the mains voltage.
• Operation is only permitted on 230V ~ / 50Hz mains voltage
• Remodeling, changing or expanding the product is not permitted.
• Make sure that the mounting surface supports the weight of the product permanently and reliably at all times, even
in changing weather conditions (eg storm).
• The ambient temperature during operation must not exceed 45 ° C!
Installation instructions for power connection:
Connection: The wall lamp is delivered ready for connection with an approx. 20 cm connection cable and a plastic
connection box. The connection box is equipped with sealing cable glands on both sides. The connection cables are to
be led through the rubber seals. The strain relief must be tightened so that the current-carrying cable is fixed. After
connecting the box, close it until it clicks into place
L: Lead phase (brown) N:
Lead neutral (blue)
PE: NOT available (is not required due to protection class 2 - double insulation
To open the cover, the retaining tab must be "levered" on the back with a screwdriver, for
example. The screws on the back are NOT required for opening. Remove the edge towards
the front and remove the 3 screws on the top.
Setting options:
LUX: 3-2000 LUX
TIME: light duration 10sec - 5min
Take off the cover and lead the
supply line through the rubber
eyelet, then connect L and N to
the luster terminal with correct
polarity. Only put into operation
after assembly.
Clever: The cover of the sensor can be completely
rotated in a circle. Hides the sliders or cuts the
angle.
Separate safety instructions for LED lighting
Never look directly or unprotected into the light or the glowing LEDs. The brightness can dazzle you severely, you risk
injuries and possible permanent damage to the eyes or the retina. Never point the light at people or animals (... if the
light is mobile)! The product must never be covered during operation and the possibility of heat dissipation into the
environment must be guaranteed. Fire hazard!
Reproduction only with permission from
ChiliTec GmbH, Bäckerberg 12, 38165 Lehr
EAR (WEEE): DE25841852
LUCID Packaging Act: DE5562476395648
GRS (UBA register) no .: 21003466
