www.childcareproducts.com.au
www.childcareproducts.com.au
4
9
General Assembly Information
The only tool required for assembly is a medium flat
screwdriver. The frame assembly slips together and is held
in place by spring retention buttons. The spring retention
buttons, herein after referred to as “Button”, must be
pressed down, such that they are nearly flush with the
surface of the tube, when assembling two components. Be
cafeful not to push the Button into the tube as it may not
pop back up. Connect two components as follows:
1. Line up two components such that the button is in line
with the hole on the mating component.
2. Depress the button and slide the two components
together until the button pops through the hole on the
second component. Always make sure that the button
pops all the way through the hole and that the two compo-
nents are firmly connected together.
Depress the but
ton
Placing the baby in the swing
1. Open the tray and place the baby in the
swing. Thread each of the baby’s arms
through the shoulder straps of the 5 point
harness. Insert the male buckles of the
shoulder/ waist straps into the female
buckle connected to the crotch strap.
2. Adjust the crotch strap so that the buckle
is located at the baby’s waist.
3. Adjust the waist straps and shoulder
straps to be snug around the child.
4. Close the tray as described above
Warning
: Always use seat belt provided. The
seat belt should be snug but comfortable.
Never leave the baby unattented in the swing.
Slide the two
components
together
Button pops all the
way through the
hole
Shoulder Strap
Squeeze
Crotch Strap
Waist
Strap
Adjust for a
snug fit
1. The seat back can be adjusted to three
positions. To adjust the recline angle of the
seat, first ensure that the swing is in the off
position.
Adjusting the Recline Angle of the seat back
1. Position the two base tubes on the floor as shown.
Connect the base tubes together with the base cross
tube as shown. Be careful that the buttons engage the
base tubes and that the frame is securely connected.
Assembling the Swing
2. Align the lower cross bar with the base tube. Connect
the lower cross bar to the base tubes by sliding the
lower cross bar from the top of the base tubes down
until it rests on top of the plastic corner fitting on the
base tubes. The lower cross bar will share the same
button that connects the leg to the base.
B
A
B
A
3. Each leg is marked with either an “A” or a “B”. Insert
the legs into the base tubes being careful to match the
“A” on the leg tube with the “A” on the base tube and
the “B” on the leg tube with the “B” on the leg tube
with the “B” on the base tube.
2. Press the seat back forward slightly so that
the pressure is relieved from the recline wire
and the wire no longer rests on the hook that
protrudes from the seat back. Readjust the
seat back to the desired recline position.
Check that the wire engages the new hook
and is firmly locked into the new recline
angle.
Warning:
Use only the fully reclined position
until your baby can hold its head upright unas-
sisted.
