Chiko SK-250AT, Instruction Manual

Page: 33 / 48

Chapter 3 Operation
CMN005-002
31
E
nglis
h
Chapter 3 Operation
3.1 Start-up Preparation
3.1.1 Installation
■
Installation location
To ensure operating safety and deliver the full performance of the device, install the device in a location
that meets the following conditions:
Item Description
Ambient temperature 0° to +40°C
Ambient humidity 80 RH% or lower (without dew condensation)
Ambient conditions Indoors (not exposed to direct sunlight), free of corrosive/flammable gases,
oil mist, and dust.
3.1.2 Wiring and Piping
■
Wiring
WARNING
•
Perform wiring firmly, without bending or pulling cables with excessive
force.
Fire or electric shock may result.
•
Ensure that the power supply conforms to the specifications of the device.
•
Be sure to connect the ground wire.
CAUTION
•
Avoid multiple connections as they can cause voltage reduction.
At reduced voltage, the device may fail to operate normally, resulting in
failure.
The device is powered by a single-phase supply.
The tolerance of the supply voltage is

10%.
1.
Connect the device attachment plug of the power cord to the power connector on the device.
2. Connect the power supply end of the power cord to the power outlet.
■
Piping
・
Connect the intake piping(separately prepared) to the suction port.
IMPORTANT
•
Ensure appropriate piping during operation.
The piping should be as short as practicable, with the piping port diameter not too
small.