Installation Instructions
12
OPTIONAL: Adding Pull Knob (XSM1U Only)
1.
If necessary due to height of tall screen, add pull knob (R) to
bottom of interface brackets (V and W) to allow easier
accessibility for adjustment purposes. (See Figure 13)
2.
Adjust length of pull knob so it is not visible below screen.
(See Figure 13)
Figure 13
Adjustments
Horizontal Adjustment
1.
The mount wall brackets may be adjusted side-to-side at
the point of attachment. (See Figure 14)
Figure 14
2.
The screen may be adjusted along rails side to side.
NOTE:
Do NOT allow both interface brackets (V and W or X
and Y) to be located on same side of wall bracket. (See
Figure 10)
NOTE:
NEVER place both interface brackets (V and W or X
and Y) to one side of the wall mount center line! (See
Figure 10)
3.
(XTM1U only)
Move latch on top of interface brackets to
CLOSED position. (See Figure 16)
Roll/Height Adjustment of Wall Brackets
NOTE:
The height adjust wall brackets allow adjustment of
+ 1/2" (12.7mm).
1.
Turn to right (tighten) to raise side of screen. (See Figure )
2.
Turn to left (loosen) to lower side of the screen.
Figure 15
(R)
(V or W)
1
2
3" (76.2mm) horizontal
1
adjustment possible
Raises screen
Lowers screen
1
2
(Screen not shown for clarity)