TS318SU/TS318TU/TS325TU
Installation Instructions
18
Height Adjustment
1.
Extend swing arms in order to gain access to the center
support.
2.
Use 1/4" hex key (BB) to adjust height adjustment screw to
raise or lower mount to desired height. Turn clockwise to
raise mount and counter-clockwise to lower mount. (See
Figure 30)
Figure 30
Roll Adjustment
1.
Loosen roll tension adjustment screw on back of faceplate
to decrease roll adjustment friction. (See Figure 31)
2.
Adjust roll position of display as desired. (See Figure 31)
3.
Tighten roll tension adjustment screw to desired friction
level. (See Figure 31)
Figure 31
Tilt Friction Adjustment
1.
Tilt display forward enough to expose screws on the side of
tilting mechanism. (See Figure 32)
2.
Adjust tilt friction adjustment screw to increase or decrease
tilt friction. (See Figure 32)
Figure 32
Lateral Shift Adjustment (Dual Stud only)
1.
Remove wall rail covers (N) to expose lateral shift
adjustment screws on wall rails.
2.
Loosen five lateral shift adjustment screws using 3/16" hex
key (CC). (See Figure 33)
3.
Loosen two lower lag screws securing lower rail to the wall.
(See Figure 33)
4.
Slide mount laterally to desired mounting position. (See
Figure 33)
NOTE:
Removing the display from the mount will make
adjusting the position of the mount much easier.
5.
Tighten two lower lag screws. (See Figure 33)
6.
Tighten five lateral shift adjustment screws. (See Figure 33)
7.
Reinstall wall rail covers (N).
raise
lower
roll adjustment
screw
1
3
2
2
(side view)
