Installation Instructions
TASMS/TAMMS
7
Assembly And Installation
IMPORTANT ! :
The TASMS/TAMMS accessory is
designed to mount Chief’s Thinstall™ wall mounting
systems to a steel studs wall. Do not attempt to install
any other mounting system to this accessory.
1.
Hold adapter plate (A) up to the wall on top of steel stud at
desired mounting location. (See Figure 1) or (See Figure 2)
2.
Mark three hole locations. The middle hole to use will vary
based on which mounting system is being used on the
TASMS. (See Figure 1) or (See Figure 2)
3.
Drill a 1/2" (12.7mm) hole at the desired mounting locations.
(See Figure 1) or (See Figure 2)
Figure 1
Figure 2
4.
Hold metal channel on anchor (D) flat alongside plastic
straps and slide channel through hole. (See Figure 3)
Figure 3
5.
Holding plastic straps on anchor (D), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See Figure
4)
6.
Slide plastic cap on anchor (D) towards wall until flange of
cap is flush with wall. (See Figure 4)
Figure 4
7.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 5)
8.
Repeat Steps 3 through 7 for the other mounting hole.
Figure 5
2
3
1/2" (12.7mm)
(A)
TS110
TS218
TS118
(TASMS)
2
3
1/2"‘1 (12.7mm)
(TAMMS)
(A)
(D)
Drywall
Plastic Straps
4
(D)
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
5
Steel Stud
6
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
7
Steel Stud
