background image

I N S T A L L A T I O N   I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280   • F:877.894.6918 / 952.894.6918

8850-000143 Rev01

©2009 Milestone AV Technologies,

a Duchossois Group Company

05/09

SSB-2100, SSM-2100, SLB-2100 and SLM-2100 Interface Brackets

SSB-2100, SSM-2100, SLB-2100 and SLM-2100 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the
specific installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING:

IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT!

 DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation Instructions

WARNING:

OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT!

 DO NOT over tighten screws when installing interface bracket.

NOTE:

Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1.

Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2.

Turn projector upside down.

3.

Place the three 1/4” nylon spacers over the three threaded inserts in the bottom of the projector.

4.

Place the interface bracket onto the three 1/4” nylon spacers on the bottom of the projector.

5.

Align the three mounting holes in the bracket with the three nylon spacers.

6.

Using the three M4 x 12mm screws, secure interface bracket to projector and tighten all fasteners at this time.

NOTE:

Security screws can be substituted when mounting interface bracket to projector by using the parts and installation

instructions in the All-Points Security Kit.

Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.

(1)  Interface Bracket

(3)  M4 -12mm Flat Head Screw

(3)  10 - 24 Thumb Nuts**

(3)  1/2" x .218 x 1/4" Nylon Spacer

(1)  All-Points Security Kit

**Only used when installing SLB/SSB interface brackets.

NOTE:

Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the

encircled locations above.  DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.

SLB-2100

SLM-2100

(Note: SSM-style interface bracket connections

are encircled)

(Note: SSB-style interface bracket connections

are encircled)

Towards front of
projector

Towards front of
projector

Reviews: