RPME
Installation Instructions
8
Installing to Threaded Rod
NOTE:
If installing RPME to anything other than a CPA
column, the CPA adapter portion must be removed
from RPME mount prior to installation. See CPA
Adapter Removal Section for details.
NOTE:
The RPME projector mount may be suspended from
four 1/4-20 threaded rods (not included) which are
secured to unistrut, angle or channel assembly
overhead structural members (trusses or I-beams) by
1/4" jam nuts (not included).
1.
Secure one end of each of the four threaded rods (not
included) to the structural member.
2.
Install four 1/4" jam nuts (not included) and four 1/4"
washers onto each threaded rod.
3.
Install RPME onto threaded rods, inserting the rods into the
four holes on top of the RPME.
NOTE:
Hole in the RPME allows socket wrench access without
unit disassembly.
4.
Secure the threaded rods to the RPME with 1/4" jam nuts
(not included) and 1/4" washers (not included). (See
Figure 10)
Figure 10
5.
Proceed to
Installing Projector with Interface Bracket
section.
PROJECTOR INSTALLATION
IMPORTANT ! :
Model RPME uses optional Chief "SLM"
Series interface brackets. See
Parts
drawing.
1.
Attach projector to interface bracket (B) using installation
instructions and hardware included with the interface
bracket.
NOTE:
Security screws can be substituted when mounting
Interface bracket to projector by using the hardware
and installation instructions in the All-Points Security
Kit (included with interface bracket).
Installing Projector with Interface Bracket
1.
Orient projector with interface bracket.
2.
Lift projector so that screws with thumb nuts are aligned
with mounting slots in mount base. (See Figure 11)
3.
Slide projector with mounting bracket into mounting slots in
mount base until screws are seated against the back of
mounting slots.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make
certain mounting slots in mount base slide under thumb
screws and that screws are seated in the back of slots.
Figure 11
3
1
Secure using
3
4
Secure with jam
nuts and washers
(not included)
Threaded
rods
(A)
jam nuts
(not included)
2
3
(Mounting structure not shown for clarity)
(A)
[Locked]
[Unlocked]
Locking
lever
5
Lock
Mounting
slots
6
