RMF2/RLF2/RXF2
Installation Instructions
10
Install Display to Wall Plate
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached does not exceed 125 lbs (56.7 kg)
for the RMF2 and RLF2 or 175 lbs (79.4 kg) for the RXF2.
Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
WARNING:
Display may be very heavy! Ensure display
can be safely lifted and maneuvered as required to install on
wall plate. Failure to take adequate precautions can result in
serious personal injury or damage to equipment!
WARNING:
Interface brackets must be hung on opposite
sides of the center tab on wall plate! (See Figure 9)
Figure 9
1.
Make sure interface brackets are in the kickstand position
by pulling down on handles as far as possible. (See Figure
10)
2.
Hang display with brackets (B) on upper rail of wall plate (A).
Kickstand should be engaged with lower portion of wall
plate. (See Figure 10)
Figure 10
NOTE:
Any cable management or rear display adjustments
should be made when the display is resting on the
kickstand.
center tab
interface brackets
must be hung on opposite
sides of center tab
5
kickstand engaged
2
1
(view from left side)
