4
Figure 2. Place Brackets on Display
Figure 3. Align Holes
INSPECT THE MOUNT BEFORE ASSEMBLY
1. Carefully inspect the mount for shipping damage (see
Figure 1). If any damage is apparent, call your carrier claims
agent and do not continue with the installation until the carrier
has reviewed the damage.
NOTE:
Read all assembly instructions before starting
assembly.
2. Carefully inspect mount components for damage.
INSTALL INTERFACE BRACKETS
ON DISPLAY
Install the interface brackets as follows:
1. Place the interface brackets (20 and 30) on the back of
the display, aligning one of the holes or top of the slots as
a reference point to align horizontally with the square
holes facing toward the center of the display (see
Figure 2 and Figure 3).
NOTE:
Spacers (180 or 190) are used to offset the
bracket if the mounting holes are recessed or to get
around the protrusions.
2. Secure the left and right factory assembled interface
bracket assemblies (20 and 30) to the display. Select the
mounting hardware that fits your application. Read the
following list and refer to Figure 4 and Figure 5.
•
Use spacers (180 or 190), if necessary.
•
Use M6 screws (80 or 90) or M8 screws (50, 60, or
70), steel washers (170), and shoulder washers
(210).
•
Or, use M4 screws (130, 140, or 150) or M5 screws
(100, 110, or 120) steel washers (160), and shoul-
der washers (200).
I N S T A L L A T I O N
I N S T R U C T I O N S
Figure 4. Attachment Parts
Figure 5. Attachment