PSMH2682
Installation Instructions
4
ASSEMBLY AND INSTALLATION
Mount Installation
1.
Attach locking flags (G) to two of four vertical brackets (A)
by installing two 5/16-18 x 5/8" button head cap screws
though lower hole on locking flags, upper hole on vertical
brackets, 5/16" washers (J) and into two 5/16-18" lug nuts
(F). (See Figure 1)
Figure 1
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which this mount
is being attached can support a minimum of 2,000 lbs
(907.18kg). Reinforce the structure as required before
installing this mount.
2.
Raise upper horizontal bracket (B) against wall in desired
installation location. (See Figure 2)
3.
Level and adjust horizontal position making certain slots in
upper horizontal bracket on mount are properly positioned
over studs.
4.
Using a pencil, or similar marking tool, mark the location of
mounting holes in base onto surface. (See Figure 2)
5.
Hang two vertical brackets (A) from upper horizontal
bracket to determine mounting position for lower horizontal
bracket. (See Figure 2)
6.
Raise lower horizontal bracket (B) against wall in desired
installation location using vertical brackets to determine
distance from upper horizontal bracket. (See Figure 2)
7.
Mark the location of mounting holes for the lower horizontal
bracket in base onto surface. (See Figure 2)
8.
Drill eight 1/4" pilot holes at marked locations. (See Figure
2)
Figure 2
9.
Secure mount to studs using appropriate hardware for
mounting surface and eight 3/8" washers (H). (See Figure
3)
Figure 3
(A) x 2
(G) x 2
(C) x 2
(J) x 2
(F) x 2
1
4
5
3
(A) x 2 (for reference, do not attach)
6
x 8
x 4
7
x 4
8
5
(H) x 8
