Model: FSA-1017
Installation Instructions
4
Page 1: ...mp Accessory Model FSA 1017 The FSA 1017 Pole Clamp Accessory is used to provide a means for attaching a desktop or wall mount to a 1 1 2 to 2 pole CAUTION To prevent damage to the Kit which could affect or void the Factory warranty and to the equipment that will be attached to it thoroughly study all instructions and illustrations before you begin the installation If you have any questions about ...
Page 2: ... on existing mount using a 5 32 hex key 40 see Figure 2 3 Uninstall button head cap screw one nylon washer and two flat washers from swing arm and set aside for reuse see Figure 2 4 Lift swing arm up and off of pivot pin and set aside for reuse see Figure 2 5 Remove large nylon washer pivot pin and Nylock nut from existing mount base and set aside for reuse see Figure 2 Figure 2 Remove Mount from ...
Page 3: ...low button head cap screw to properly seat in nut and allow tightening Figure 4 Install Swing Arm to Front Pole Mount 8 Place pole mount front with swing arm against pole in approximate mounting location 9 Place three BHCS 30 into pole mount rear 20 and place against pole aligning with mount front 10 10 Secure pole mount rear 20 to pole mount front 10 and pole by tightening three BHCS 20 using 5 3...
Page 4: ...Model FSA 1017 Installation Instructions 4 ...
