Installation Instructions
PDR Series
9
Lateral Tilt Tension Adjustment
CAUTION:
DO NOT OVERTIGHTEN LATERAL TILT
ADJUSTMENT NUT. Overtightening lateral tilt adjustment
will cause excessive wear and may distort adjustment
components.
1.
Using a 9/16” wrench (not provided), slightly tighten or
loosen lateral tilt tension adjustment nut. (See Figure 10)
2.
Attach the display and check for desired tilt tension.
3.
Repeat Steps 1 and 2 until desired tilt tension is obtained.
Rotational Tilt Tension Adjustment
1.
If necessary, loosen or tighten bottom rotational tilt tension
adjustment nut. (See Figure 10)
2.
Attach the display and check for desired rotational tilt
tension.
3.
Repeat Steps 1 and 2 until desired rotational tilt tension is
obtained.
Figure 10
Swing Arm Adjustments
The dual swing arms are shipped installed in the center of the
top and bottom mounting brackets, which is the standard
mounting configuration.
The top and bottom mounting brackets have slotted holes,
allowing for lateral adjustment of the dual swing arms.
After the top and bottom mounting brackets have been installed
between two wood studs 16” on center, the swing arms can be
adjusted or moved off center, depending on the location of the
mount, the size of the display, and the lateral movement
needed to rotate the display.
The swing arms can be adjusted, as follows:
•
Adjusting the Swing Arms Off-Center
With no disassembly required, you can adjust the swing arms
up to 1-inch to the left of center or up to 1-inch to the right of
center.
•
Reconfiguring the Swing Arms Left of Center
With some disassembly and reassembly required, you can
move the swing arms to the left of center by reconfiguring the
mount. Use the first and third slotted holes in the top and
bottom mounting brackets.
•
Reconfiguring the Swing Arms Right of Center
With some disassembly and reassembly, you can move the
swing arms to the right of center by reconfiguring the mount.
Use the third and fifth slotted holes in the top and bottom
mounting brackets.
Adjusting the Swing Arms Off Center
1.
Remove the display from the mount.
2.
Loosen four bolts (two on the top and two on the bottom)
securing the swing arm assembly to the top and bottom
mounting brackets (See Figure 11).
3.
Move the swing arm assembly to desired location.
4.
Tighten the bolts.
5.
Install the display on the mount.
Figure 11
Reconfiguring the Swing Arms to the Left or Right of
Center
1.
Remove the display from the mount.
2.
Remove four bolts (two on the top and two on the bottom)
securing the swing arm assembly to the top and bottom
mounting brackets (See figure 14).
Rotational Tilt
Adjustment Nut
Lateral Tilt
Adjustment Nut
Top Bolts
