Installation Instructions
PACCC2
7
2.
Verify latching flag is in the OPEN position. (See Figure 7)
3.
Align four mounting buttons on display with four teardrop
mounting holes in accessory.
4.
Slide mounting buttons into teardrop mounting holes and
lower display until recessed area of mounting buttons is
seated in lower area of teardrop mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SEVERE PERSONAL
INJURY OR DAMAGE TO EQUIPMENT. Make sure ALL
mounting buttons are properly seated in lower area of four
teardrop mounting holes.
5.
Move latching flag to CLOSED position to secure display on
accessory. (See Figure 7)
NOTE:
A padlock or similar device can be used to provide
additional security.
Figure 7
Adjustments
The PACCC2 allows for vertical adjustment of the speaker to
provide a flush installation against the bottom of the display.
The PACCC2 also provides up to 10° of YAW adjustment for
proper speaker alignment with bottom of display.
To adjust speaker vertical position:
1.
Loosen two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench
(F). (See Figure 8)
2.
Reposition speaker up or down to desired position.
3.
Tighten two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench
(F). (See Figure 8)
Figure 8
To adjust speaker YAW position:
1.
Loosen three button head cap screws securing speaker
mounting bracket to horizontal bracket using 1/8" hex
wrench (F) provided. (See Figure 9)
2.
Reposition speaker to desired position.
3.
Tighten two button head cap screws securing speaker
mounting bracket to horizontal bracket using 1/8" hex
wrench (F) provided. (See Figure 9)
Figure 9
Route cables and wires to display and speakers following
speakers manufacturer’s installation instructions.
OPEN
2
3
4
5
Display
CLOSE
Latching Flag
2
3
1
x 4
(bottom view)
2
3
1
x 3
