Installation Instructions
MWH
5
Mount Installation
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which the MWH is
being installed is capable of supporting five times the
combined weight of the mount and all attachments.
1.
Determine mounting location taking into consideration
display size and mount movement.
2.
Using a stud sensor locate stud. (See Figure 2)
3.
Using two people, place mount against wall and level mount
aligning mounting holes in upper and lower wall channels
with stud. (See Figure 2)
NOTE:
Horizontal location can be adjusted right or left as long
as the upper and lower mounting holes align with one
another on stud.
4.
Use a pencil mark two mounting holes making sure
mounting holes are located as close as possible to center of
stud. (See Figure 2)
5.
Drill two pilot holes where the mounting holes were marked
using a 7/32” (6mm) drill bit. (See Figure 2)
6.
Install one 5/16" x 2-1/2" lag bolt (G) and one 5/16" flat
washer (H), through mounting holes in upper wall channel
and into pilot hole. DO NOT tighten at this time.
(See Figure 3)
7.
Using two people place mount against wall aligning
mounting holes in upper wall channel with lag bolt and hang
mount on lag bolt making sure washers are located in front
of mount.
8.
Install one 5/16" x 2-1/2" lag bolt (G) and one 5/16" flat
washer (H), through mounting holes in lower wall channel
and into pilot hole. (See Figure 3)
9.
Tighten all hardware. DO NOT overtighten!
Figure 2
7/32" (Ø 6mm) x2
Mounting holes
centered on
studs
1
3
4
5
Figure 3
9
(G) X 2
7
(H) X 2
