MSTU
Installation Instructions
6
Figure 4
(B) x 2
5
(E-Q) x 4
(R) x 4 (if necessary)
(S or T) x 4 (if necessary)
(U or V) x 4 (if necessary)
flag in open position
5.
Install four button head cap screws (E-Q) through required
washers (R) and shoulder washers (S or T), interface
brackets (B), spacers (U or V) and into holes on back of
display. (See Figure 4)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1 kg). ALWAYS use two people and
proper lifting techniques when installing display.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the MSTU up to (and
including) the display does not exceed 125 lbs (56.7 kg).
NOTE:
Make sure locking flags are in the open position before
attaching display to wall plate. Flags are shown in the
open position in Figure 4.
NOTE:
Display can be adjusted horizontally as long as guide
hooks are securely attached to wall plate.
IMPORTANT ! :
If spacers are required, be sure to use
screws that are longer than the spacers but of the same
diameter!
6.
While supporting both sides of display, lift display up to the
wall plate on the wall.
7.
Slowly guide hooks on top of interface brackets on top of
wall plate in desired mounting location. (See Figure 5)
8.
Slowly swing display toward wall. (See Figure 5)
9.
Slowly pull bottom of display away from wall until kickstand
fully reaches its down position. (See Figure 6)
10. Slowly release display until kickstand locks against bottom
of mount.
11. Rotate flags on each interface bracket to the closed position
in order to lock brackets to wall plate. (See Figure 6)
