Installation Instructions
MSBU / PSBU
5
INSTALLATION
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Only use hardware provided or specified by
manufacturer.
1.
Determine and mark the vertical center position between
the Left side Upper and Lower mounting holes in display.
(See Figure 1)
2.
Determine and mark the vertical center position between
the Right side Upper and Lower mounting holes in display.
(See Figure 1)
3.
Orient vertical mounting bracket (T) so that mounting holes
are on top and mounting slots are on bottom. (See Figure 1)
4.
Align mounting holes in vertical mounting bracket (T) with
upper and lower mounting holes in display.
5.
Adjust vertical mounting bracket (T) position until mark
made in Step 1 aligns with center mark in vertical mounting
bracket (T).
6.
Secure Left side vertical mounting bracket (T) to display
using flat washer(s), and Phillips pan head screws
(B through M). (See Figure 2)
NOTE:
See Table 1 below for washer(s) to use with each size
screw.
Table 1: Washer Size
7.
If the display has a recessed mounting surface, protrusions
or a power box, a spacer and longer mounting hardware
must be placed between the display and vertical mounting
bracket (T). (See Figure 2)
8.
Repeat Steps 3 through 6 for Right side vertical mounting
bracket using the same hole locations to align brackets
horizontally.
Figure 1
Screw size
Washers to use
4mm (K, L, M)
P, Q, or R
5mm/6mm (E, F, G, H, I, J)
R
8mm (B, C, D)
None
4
1
(T) x 2
Mounting holes
Mounting Slots
Figure 2
8
6
(T) x 2
(N,O,P, or Q) x 4
washers x 4
(B through M)
x 4
(See Table 1)