MCS6000 Series
Installation Instructions
6
Figure 4
Removing Display from MCS
1.
Disconnect all power/audio/video cables.
2.
Remove bolt or padlock from faceplate (if used).
(See Figure 5)
NOTE:
The pin may have been used as a more permanent
locking device. If so, remove nut and pin and move
from the lower holes to the upper holes.
3.
Pull back on flag on upper mounting hole and press pin
down into "Open" position. (See Figure 5)
WARNING:
THE DISPLAY MAY WEIGH IN EXCESS OF
40 LBS EACH! Always use two people and proper lifting
techniques when installing or positioning display on MCS.
4.
Carefully lift display from MCS.
5.
Lift up on pin and place flag back against faceplate to return
it to "Closed" position. (See Figure 5)
Figure 5
Adjusting Display
CAUTION:
Watch for pinch points. Do not place fingers
between moveable parts.
Adjusting Roll
1.
Using a 9/16" wrench, loosen the Nylock roll adjustment nut
on back of mounting plate. (See Figure 6)
2.
Tilt the faceplate left or right as required.
3.
TIghten nut.
NOTE:
Do NOT overtighten fasteners.
Adjusting Pitch
1.
Adjust display to the desired pitch.
2.
Using the 5/32" hex head wrench (B), tighten the pitch
adjustment screw to hold mount in position. (See Figure 6)
4
5
May remove
pin and nut and
move to lower holes
A padlock or bolt
may be placed
through latch holes
2
1
Remove bolt
or padlock
if used
Pin in
"Open"
position -
Pin in
"Closed"
position -
4
move to
"Open"
position to
move to
"Closed"
position
remove
display
after display
is removed.
