Installation Instructions
KWP130 / KWP230
7
3.
Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
4.
Place the four selected spacers over each of the mount
holes on the back of the display.
5.
Pick up and orient the Centris bracket (B) so that the
mounting holes are aligned with the holes in the spacers;
rotate the Centris bracket as required. (See Figure 9)
Figure 9
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
6.
Using Phillips screwdriver, install four selected screws (M or
N) through the mounting holes in Centris bracket, through
the spacers (J or K), into the display. (See Figure 9) Tighten
all four screws. Do not overtighten!
7.
Return to
Centris Bracket to Array
section to complete
installation.
Adjustments
If previously attached, disconnect cables from display, then
remove display.
VERTICAL POSITION ON ARRAY
1.
Using your fingers, slightly loosen adjustment knob A. (See
Figure 10)
2.
Slide display to desired position.
3.
Using your fingers, tighten adjustment knob A.
Figure 10
PITCH / YAW / ROLL
1.
Using your fingers, slightly loosen adjustment knob B. (See
Figure 10)
2.
Adjust display as desired.
3.
Using your fingers, tighten adjustment knob B.
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8" or less
J (3/8" long)
M (M4 x 20mm)
More than 3/8" up to
and including 3/4"
K (3/4" long)
N (M4 x 30mm)
(M or N) x 4
(B)
(J or K) x 4
Knob B
Knob A
