Installation Instructions
KRA234
5
ASSEMBLY AND INSTALLATION
1.
Disassemble mount frame (A) by unscrewing two knobs
from the carriage bolts that hold the frame together. Set
aside all hardware for re-use. (See Figure 1)
Figure 1
2.
Carefully place display face down on protective surface.
3.
Connect front frame to display
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x12mm screws (G) through corresponding
holes on front frame and into the mounting holes
on the display. (See Figure 2)
Figure 2
For recessed mounting hole installation:
•
Place four spacers (H or J) on top of mounting
holes on back of display. (See Figure 3)
•
Using Phillips screwdriver, carefully install four
M4x30mm (E) or M4x20mm (F) Phillips screws
through corresponding holes on front frame,
spacers (H or J) and into the mounting holes on
the display. (See Figure 3)
Figure 3
4.
Use four M4x6mm Phillips screws (L) and four M4 lock nuts
(K) to secure faceplate to back frame. (See Figure 4)
NOTE:
For K1 Series mounts, remove faceplate prior to
connecting to KRA234 for easier connection.
Figure 4
carriage bolts x 2
back frame
front frame
lock nuts x 2
x 2
1
(display and faceplate
hidden for clarity)
3
(G) x 4
front frame
3
(E or F) x 4
front frame
(H or J)
4
(L) x 4
back frame
K1 faceplate
(to K1 Series)
back frame
K2 faceplate
(to K2 Series)
4
(L) x 4
(K) x 4
(K) x 4
