K4G220-320
Installation Instructions
6
Assembly And Installation
1.
Use four 1/4-20 x 1 1/4” flat head cap screws (C) to secure
grommet plate (K) to column arm (H). Make sure longer legs
of grommet plate are aligned with the front of column. (See
Figure 1)
Figure 1
2.
Locate a flat surface (thickness minimum of 1" to maximum
of 5") on which to mount the array assembly.
3.
If a hole doesn’t already exist, drill a hole in desk with a
diameter between 1/2” and 3” at desired mounting location.
(See Figure 2)
4.
Position mount on desk so that center hole of grommet plate
(K) is centered over grommet hole. (See Figure 2)
5.
Insert grommet screw (J) through grommet hole and thread
into center hole of grommet plate (K). (See Figure 2)
6.
Tighten grommet screw (J) until grommet base is tightened
against underside of desk and mount is securely mounted
to desk. (See Figure 2)
Figure 2
7.
Carefully manipulate base cover (E) to create an opening
large enough to wrap cover around array column. (See
Figure 3)
8.
Wrap base cover (E) around column and slide it down until
base cover fits securely onto grommet plate (K). (See
Figure 3)
Figure 3
9.
Tighten two socket head cap screws to secure each column
arm at desired height. (See Figure 4)
10. Install column cap (D) to column (H). (See Figure 4)
Figure 4
(K)
(H)
1
(C) x 4
front of column
4
6
6
diameter between
3
(J)
1/2” and 3”
7
7
8
(E)
(K)
9
10
(D)
(H)