Installation Instructions
KFCD
5
Grommet Thru-Bolt (.375” - 3” Diameter Hole)
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
1. Remove three screws and the base bracket from the bottom of
the desk clamp (see Figure 3).
2. Using the 3/16” hex wrench (provided), loosen the clamp bolt
and remove the clamp.
3. Rotate the base bracket 180 degrees and install the base bracket
on the clamp.
4. Slide the 5/16-18 x 4” button head cap screw through the hole
in the bar.
5. Secure the bar, with the 5/16-18 x 4” button head cap screw
under the work surface, to the tapped center hole of the base
bracket in the desk clamp (see Figure 8).
Tapped Hole
in
Base Plate
Bar
5/16-18 x 4”
Button Head
Cap Screw
Figure 8. Secure using Bar
