Installation Instructions
KFA SERIES
7
Installation
1.
Determine proper pole clamp to use for installation. If
mounting to wide portion of pole mount use large pole
clamp bracket (K). If mounting to extendable upper portion
of mount, use small pole clamp bracket (J). (See Figure 1)
Figure 1
NOTE:
If removing existing head assembly from cart/stand, do
so prior to installing KFA Series arrays.
IMPORTANT ! :
The KFA Series arrays can be used in
addition to the existing head assembly as long as the
overall weight limit of the cart/stand is not exceeded!
2.
Attach pole clamp bracket (J or K) to pole mount front
using two 1/4" washers (L) and two 1/4-20 x 3/4"
button head cap screws (M). (See Figure 2)
3.
Secure pole clamp bracket (J or K) to pole mount front
and pole by tightening two button head cap screws
(M) using a 5/32" hex key (H). (See Figure 2)
Figure 2
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION:
If display uses a screw size other than
those included in the kit, DO NOT use the screws
provided. Using the wrong screws could result in
damage to your monitor.
1.
Install two M4 x 12mm Phillips pan head screws (C)
into two upper mounting holes in display back.
(See Figure 3)
NOTE:
DO NOT fully tighten at this time.
2.
Hang display on Centris head. (See Figure 4)
3.
Install bottom two M4 x 12mm Phillips pan head
screws (C) through Centris head mounting holes and
into lower mounting holes in display back.
4.
Tighten four M4 x 12mm Phillips pan head screws
(C). (See Figure 5)
Table 1: Parts
ITEM
DESCRIPTION
QTY*
A
ARRAY ASSEMBLY, KFA-220/225
1
B
ARRAY ASSEMBLY, KFA-320/325
1
C
SCREW, Phillips Pan Head, M4 x 12mm
4
D
SCREW, Phillips Pan Head, M4 x 30mm
4
E
SPACER, Nylon, 3/4" (used with item D)
4
F
SPACER, Nylon, 3/8" (used with item G)
4
G
SCREW, Phillips Pan Head, M4 x 20mm
4
H
KEY, Hex, 5/32"
1
J
BRACKET, Pole Clamp, Back - small
1
K
BRACKET, Pole Clamp, Back - large
1
L
WASHER, Flat. 1/4"
2
M
SCREW, Button Head, 1/4-20 x 3/4"
2
* Quantity varies depending upon the number of displays being
mounted.
(J)
(K)
(J or K)
(M) x 2
(L) x 2
(A or B)
pole mount
