K1W/K1S Series
Installation Instructions
14
NOTE:
Tension may also be adjusted with upper tension
adjustment screw inside cable management cover and
1/8” hex key (N). (See Figure 17)
Figure 17
Adjustments - K1W22H/K1S22H models only
Display Adjustments
1.
Loosen knobs securing faceplates to array. (See Figure 18)
2.
Slide displays laterally on array to adjust lateral shift. (See
Figure 18)
3.
Adjust pitch and pivot position as desired. (See Figure 18)
4.
Tighten knobs to secure faceplates in position. (See Figure
18)
Figure 18
Array Bar Roll Adjustment
1.
Loosen roll adjustment screws on back of array bracket.
(See Figure 19)
2.
Adjust roll of array bar as desired. (See Figure 19)
3.
Tighten roll adjustment screws on back of array bracket.
(See Figure 19)
Figure 19
Display Removal
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 20)
1.
Make sure display is in the upright position.
2.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 20)
Figure 20
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
2
3
2
1
4
3
3
3
1
3
2
2
quick release tab
2
