Installation Instructions
K1C1KRA204-K1C2KRA204
7
For recessed mounting hole installation:
•
Place four spacers (D) on top of mounting holes
on back of display. (See Figure 5)
•
Using Phillips screwdriver, carefully install four
M4x25mm screws (C) through corresponding
holes on faceplate, spacers (D) and into the
mounting holes on the display. (See Figure 5)
Figure 5
4.
Position display with faceplate attached above mount. (See
Figure 6)
5.
Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 6)
Figure 6
Adjustments
Head Tilt Adjustment
1.
Adjust head tilt to desired tilt position. (See Figure 7)
2.
Adjust head tilt tension screw to change the adjustment
tension. (See Figure 7)
Height Adjustment
CAUTION:
OVERTENSIONING THE HEIGHT-
ADJUSTMENT TENSION SCREW MAY CAUSE DAMAGE!
Do NOT over-tighten height-adjustment tension screw when
adjusting tension for lighter or heavier displays.
1.
Adjust arm height to desired level. (See Figure 7)
2.
Open cable management cover on upper arm to expose
height-adjustment tension screw. See Cable Management
section for details.
3.
Use 1/8” hex key (J) to adjust height-adjustment tension
screw to change adjustment tension. (See Figure 7)
NOTE:
Turn clockwise to reduce tension for lighter displays
and counter-clockwise to increase tension for heavier
displays.
4.
Close cable management cover on upper arm. See Cable
Management section for details.
Pivot Adjustment
1.
Adjust pivot position as desired. (See Figure 7)
2.
Use 3/16” hex key (H) to adjust pivot point tension screws
to change pivot adjustment tension. (See Figure 7)
Figure 7
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
5
head tilt
pivot point
tension
tension
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
3
(K1C1KRA204 shown)
