JWDSK210
Installation Instructions
8
Figure 11
CABLE MANAGEMENT
1.
Attach all cables to display.
CAUTION:
Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of cover (B) or screws (T).
2.
Carefully insert cables in cavity located in lower
portion of mount arm (See Figure ).
3.
Using Phillips screwdriver, install cover (B) with two
screws (T). (See Figure )
Figure 12:
ADJUSTMENTS
Swing Arm
PIVOT / SWING
1.
Using 3/16" hex key, slightly loosen or tighten the
adjustment screw(s) as necessary (See Figure 13).
Figure 13
Centris Head
1.
If previously attached, disconnect cables from display, then
remove display.
2.
Using Phillips screwdriver, slightly loosen or tighten
the adjustment screw as necessary (See Figure 14).
Figure 14
(X) x 1
(C) x 2
(T) x 4
Cable Path
(typical)
(B) x 2
Adjustment Screws
Adjustment Screw
Phillips Screwdriver
