Installation Instructions
JSB210
5
INSTALLATION
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Only use hardware provided or specified by
manufacturer.
1.
Determine pattern of mounting holes in back of display.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DAMAGE TO EQUIPMENT OR TO MOUNT FALLING
CAUSING SERIOUS PERSONAL INJURY ! Use proper size
and length hardware depending on display.
200mm x 100mm Mounting Hole Pattern
2.
Use six nylon spacers (J) and six flat head screws (D) to
attach JSB210 interface bracket to the display back.
(See Figure 1)
Figure 1
200mm x 200mm Mounting Hole Pattern
3.
Use four nylon spacers (J or P) and four Phillips cap head
screws (E through H, L through N) to attach JSB210
interface bracket to the display back. (See Figure 2)
NOTE:
Phillips cap head screws should be placed through
either the square or round holes in the interface bracket
corners.
•
Use M4 cap head screws through SQUARE
holes.
•
Use M6 cap head screws through ROUND
holes.
Figure 2
CAUTION:
PREVENT EQUIPMENT DAMAMGE! Tighten
each screw carefully, but do NOT overtighten.
Attach Display to Mount
1.
Start two Phillips pan head screws into top mounting holes
on interface bracket (A). (See Figure 3)
2.
Align two screws in interface bracket (A) with upper
mounting holes in Centris cup and lower display until
screws are seated in lower area of teardrop mounting
holes. (See Figure 3)
Figure 3
2
(D) x 6
(J) x 6
3
(E through H,
L through N) x 4
(J or P) x 4
M4 screws placed
through square holes
M6 screws
placed through
round holes
x 4
2
(A)
