Installation Instructions
MSP-BBST
6
INSTALLATION
The following procedures describe how to install the
tilt mount.
NOTE:
Read “Warnings and Cautions” on Page 2.
Wall Stud Installation (Step 1)
Install the wall bracket on a wall stud, as follows:
1. Determine the exact mounting location prior to
installation, considering screen size as well as
the mount swing and extension radius.
2. Position the wall bracket (20) as desired.
NOTE:
Mark the mounting holes as accurately as
possible before drilling the holes. The holes
must be centered for the wall bracket to fit
correctly on the wall.
3. Locate stud and, using wall bracket (20) as a
template at the desired height, mark the location
of the two center mounting holes.
4. Using the two wood screws (30), secure wall
bracket (20) to wall.
Attaching the VESA Bracket to the
Display (Step 2)
Depending on the VESA hole-pattern on your
display, select the applicable set of instructions,
listed below, to attach the VESA bracket to your
display:
•
Flush Mount (Without Bracket Adapter)
−
75mm/75mm compliant displays
−
100mm/100mm compliant displays
−
200mm/100mm compliant displays
•
Recessed Mount (spacers are used)
−
75mm/75mm compliant displays
−
100mm/100mm compliant displays
−
200mm/100mm compliant displays
•
Flush Mount (With Bracket Adapter)
−
200mm/200mm compliant displays
CAUTION:
If monitor uses a screw size other than those
included in the kit, DO NOT use the screws provided.
Using the wrong screws could result in damage to
your monitor.
Figure 1. Installing Wall Bracket — Wall Stud
Center
Mounting
Holes
Mounting
Hole
20
