Installation Instructions
FCA870
7
Installing Camera (not included)
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight mounted on
the FCA870 shelf does not exceed 10 lbs (4.5 kg).
WARNING:
Use of this accessory will decrease the weight
capacity of the mounting system to which it is attached by the
combined weight of the accessory and all components
supported by this accessory!
WARNING:
Use of this accessory will NOT decrease the
weight capacity of the shelf or bracket accessory to which this
accessory is attached. (See Figure 9)
Figure 9
WARNING:
Camera must be secured to FCA870 shelf
using either adhesive hook and loop squares (J) or screws (G
or H)! Failure to securely mount camera to shelf may result in
serious personal injury or damage to equipment!
NOTE:
OPTIONAL
: Slots are provided in shelf for strap (not
included) to hold camera in place. (See Figure 10)
Using Adhesive Squares
1.
Use up to eight adhesive hook and loop squares (J) to
secure camera to shelf. Attach adhesive squares to bottom
of camera first and then attach corresponding squares to
shelf when the exact mounting location has been
determined. (See Figure 10)
Using Screw(s)
NOTE:
Screw mounting options will vary based upon camera
model.
2.
(Single Screw option) Install 1/4-20 x 3/8” Phillips pan
machine screw (G) through mounting slot on shelf and into
hole on bottom of camera. (See Figure 10)
3.
(Multiple screw option) Install four #4-48 x 1/4” Phillips pan
machine screws (H) through outside mounting slots and into
holes on bottom of camera. (See Figure 11)
4.
Route cable from camera towards back of shelf and up
behind the FCA870. (See Figure 10) and (See Figure 11)
Figure 10
Figure 11
10 lbs (4.5 kg)
10 lbs (4.5 kg)
existing shelf (example)
FCA870 shelf
Slots provided
for strap
(not included)
2
(G) x 1
Camera
(example -
4
not included)
1
(J) x 4
Slots provided
for strap
(not included)
3
(H) x 4
Camera
(example -
4
not included)
