Installation Instructions
FTR1U / FTR100
7
2.
Lift and maneuver display such that all mounting buttons fit
into openings on FTR1U/FTR100 assembly (A). (See
Figure 7)
3.
Lower display firmly into place. Ensure each mounting
button has fully seated in the opening. (See Figure 7)
4.
Close latching flag by rotating flag counterclockwise on
FTR1U/FTR100 assembly (A). (See Figure 7)
Figure 7
NOTE:
Example shows mounting display in the 100mm x
100mm pattern. FTR1U/FTR100 assembly (A) will also
accommodate a 75mm x 75mm pattern. (See Figure 8)
Figure 8
NOTE:
An optional padlock may be used to secure latching flag
in place. (See Figure 9)
Figure 9
5.
Connect cables to display as required.
Adjusting Tilt
1.
Loosen adjusting screws on each side of display (See
Figure 10).
2.
Adjust tilt as desired.
3.
Tighten adjusting screws.
Figure 10
2
3
Display
(A)
4
Latching flag
Button location for
100mm x 100mm
pattern (4 places)
Button location for
75mm x 75mm
pattern (4 places)
NOTE: Display not shown for clarity.
NOTE: Display not shown for clarity.
Add padlock here
5° Tilt Up
15° Tilt Down
1
2
3
