FRA
Installation Instructions
6
Prior to Installation
NOTE:
If the display is already attached to the mounting
system, be sure to remove it before proceeding with
installation of this accessory.
NOTE:
The four nuts along the outside edge of rotation plate
may be tightened to increase the friction of the plate, or
loosened to decrease friction. (See Figure 1)
NOTE:
Direction of rotation MUST be determined before
proceeding with the installation (Refer to orientation of
rotation plate.)
•
See Drawing A (See Figure 1) to install the bracket
to allow clockwise rotation when looking at the
back of the display.
•
See Drawing B (See Figure 1) to install the bracket
to allow counter-clockwise rotation when looking
at the back of the display.
Figure 1
Installation
1.
Center the mounting system brackets on the FRA
accessory, matching center of brackets with center
indicators marked on FRA. (See Figure 4)
2.
Install mounting system brackets to the FRA accessory (A)
using four 5/16-18 x 1/2" button head cap screws (C). (See
Figure 2)
Figure 2
3.
Attach display to FRA (A) using hardware included with
mounting system, and following installation instructions
included with the mounting system. (See Figure 3)
Figure 3
4.
Hang FRA with attached display onto mounting system
following instructions included with mounting system.
A
[CLOCKWISE]
B
[COUNTERCLOCKWISE]
x 4,
OR
x 4
[Tighten or loosen four outside
nuts on rotation plate to increase
or lessen friction.]
1
(C) x 4
[Mounting system
brackets - not included]
(A)
[FMSIML shown as example]
[400 x 400 mounting pattern shown as example]
